Installation Manual

PX/QX with Coupler Installation Manual Version *61
Figu
re 19 Multiple Aisles
Secondary antenna (SAB) wiring
Follow the same steps as they are described in Single-Aisle Wiring SAB section.
Pri
mary antenna (PAB) wiring
Step 1 to Step 5 are the same as they are described in Single-Aisle PAB wiring section.
Ste
p 6: Connect the sync cable to J 10 and J9 on the electronic reader board (TR4026).
Step 7: Connect 24v DC power cable to J8 on the electronic reader board (TR4026). Connect
another 24VDC power cable to J12 if there is a PAB powered via this PAB.
Step 8: Inspect wiring and connections, confirm coupler board jumper settings (see Figure 17
PAB Coupler Board Jumper Settings).
Step 9: Put the base cover(s) back and secure.