Installation Manual

PX/QX with Coupler Installation Manual Version *61
Primary antenna (PAB) wiring
Step 1: Open the base cover(s).
Ste
p 2: Cut, strip and terminate the RG59 coax cable, then plug it to the coupler board. Check the
coupler board jumper settings (see Figure 17 PAB Coupler Board Jumper Settings).
Step 3: Connect the SAB Light Cable wires to the J11 on the electronic reader board (TR4026).
Step 4: Connect network and peripheral cables (see next Chapter, Network and Peripheral
Wiring), if required.
Step 5: Connect 24v DC power cable to J8 on the electronic reader board (TR4026).
Step 6: Inspect wiring and connections, confirm coupler board jumper settings (see Figure 17
PAB Coupler Board Jumper Settings).
Step 7: Put the base cover(s) back and secure.
T2 T1 T3
J2 J4 J1 J3
C7
C6C3
C4
C5
C8
C1
R2
R1R3 R4
L1
J11
J10
J
9
PRI
PRI
SEC
SEC
J6
J7
J8
J5
J12
J13
T2 T1 T3
J2 J4 J1 J3
C7
C6C3
C4
C5
C8
C1
R2
R1R3 R4
L1
J11
J10
J
9
PRI
PRI
SEC
SEC
J6
J7
J8
J5
J12
J13
PX PAB Coupler Board Jumper Setting QX
PAB Coupler Board Jumper Setting
Figure 17 PAB Coupler Board Jumper Settings