Installation Guide Part 3

NGL FX Installation Manual Rev. * 48 of 84
9. Navigate to the Antenna Settings window.
10. Under each Antenna Tab, fill in the following parameters:
• Antenna Type: Set to PAB-SAB.
• Jammer Threshold: Set to 0.
• TX Maximum: Set to 31.
• RX Gain: Set to 31.
• RX Hardware Gain: Set to 31.
• Port Control: Check RX, TX and Port. Do not check AGC.
11. Click on Apply. Figure 29X*** shows the Antenna Settings for NGL.
Figure 27X*** Antenna Settings
Multi-Aisle Setup – FX Systems operating in Sync***
The difference between a multi-aisle system and a single-aisle system is that the multi-aisle system
has one aisle designated the "master system" and all other aisles are designated the "submaster
system". When a Multi-Aisle System is used, and extra step is necessary to configure the NGL
Master/Submaster designation. Figures ***28 and 29 illustrate the difference between a Single-
Aisle and a Multi-Aisle System. A Multi-Aisle System makes use of a Sync cable between the
PAB antennas for each aisle. The Master PAB provide the "Sync" signal to the Submaster PAB(s).