Installation Guide Part 3

NGL FX Installation Manual Rev. * 78 of 84
Finishing Installation
Power the system up. Only after the system is fully tuned should the floor cuts be filled with the
flooring material. Concrete mortar, grout, and/or other sealants are applied during this final step,
ensuring the antenna locations are not visible. As mentioned in the site survey***, it is crucial that
the grout be non-metallic and non-magnetic.
Note: If this is a single antenna configuration, then turn off the Transmitter for TX2.
Place Thoro Waterplug Hydraulic cement or Quickrete Fast Set Repair Mortar over all floor cuts.
***Note: Detection performance of the system may be temporarily affected by the water content
in the repair mortar. As the mortar mix cures, detection performance improves.