Installation Guide Part 3

NGL FX Installation Manual Rev. * 46 of 84
Figure 23X*** DMS Network and Task Manager View
2. Navigate to the Switch Settings window.
3. Under the Detection Tab, fill in the following parameters:
• RF Group Address: choose and address between 1 and 6. The address should
match any other PAB in the system (if Multi-Aisle is configured).
• Sync Mode: set to "NGL Sync Mode".
• TX Control: set to Enabled, Mode 2.
4. Click on Apply. Figure 26X*** shows the Detection parameters for NGL.
Figure 24 Detection Settings
5. Under the Tuning Tab, fill in the following parameters:
• Sampling Holdoff: Set to 13.
• Independent Antenna Alarm: Set to Enabled.