Installation Guide Part 3

NGL FX Installation Manual Rev. * 59 of 84
24. To activate the Mapping Matrix menu, check the box directly to the left of Mapping
Matrix.
• From the Trigger drop down menu, select the event code that needs to be altered or set.
• Then, in the Action drop down menus, choose from a sounder alarm pattern, a light alarm
pattern, no action or output subnode in the left pull down.
• Once the alarm pattern has been selected, choose from the different custom patterns that
were established on the previous tab (see*** Figure 36: Alarm Patterns Enabled), which
are numbered in the right pull down.
• To finish coupling the selected alarm trigger with the custom alarm pattern, click Add.
The trigger appears on the right, where all alarm trigger and their alarm response patterns
are listed (see*** Figure 38: Matrix Tab).
• If necessary, an alarm trigger and the subsequent response can always be removed by
clicking Delete.
Note:
Selecting 00 in the drop down box will use the Light or Sounder settings that are under the Alarms tab in the Switch
settings menu.
Updating the System
Once the system is properly configured, click the Apply button. This loads all the new alarm
settings, patterns, and matrices into the Evolve system, updating it.