Installation Guide Part 1

NGL FX Installation Manual Rev. * 34 of 84
TR4215 Components and Enclosure
Overview
Connections to the Electronics Enclosure / reader assembly are listed below. This section
describes how to prepare and wire all cables and wires involved in the antenna installation.
TR4215 board with all interfaces labeled. A ferrite clip (CKP P/N 7284760) (Fair Rite P/N
044380640) is installed on all TR4024 I/O cables shown below.
Figure 11: Electronics Enclosure panel
Connector type: Riacon, 4 terminal
Cable type: 22 AWG, 4-conductor with drain wire