User's Manual
Table Of Contents
- Statements
- Table of Contents
- ILS Open Plus Exit Antenna Installation
- Requirements
- Overview
- Safety Instructions - Read Before Beginning
- Gate Features
- Site Survey
- Disassemble the Gates
- Install the Gate Base
- Connecting the Alarm Kit to the Serial-to-Ethernet Board
- Install the Antenna Body
- Install the Cover Plates
- Antenna Configuration
- Testing the Gate Antenna
- Technical Data
- Appendix
1-2 ILS Open Plus 3.0 Installation Manual
8 “Install the Cover Plates” on page 1-16
9 “Antenna Configuration” on page 1-18
10 “Testing the Gate Antenna” on page 1-23
11 “Technical Data” on page 1-26
Safety Instructions - Read Before Beginning
• Before working with the gate, the power supply must always be unplugged. An
upowered LED is not an indicator for an unplugged power supply.
Caution: The Antenna-Tuner and the Antenna conductor can carry voltages up to 1000V.
Gate Features
The gates are intended to be used in pairs, with one primary smart gate that contains the
Reader and Multiplexer, and a secondary dumb gate without a Reader or Multiplexer. The
Reader and Multiplexer are mounted inside the antenna base of the primary gate.
The primary gate controls all of the functions for all of the gates at the entrance/exit, by
quickly time-multiplexing the RF field amongst them, effectively covering the entrance/
exit with one large RF field.
The antennas are comprised of the electrical antenna conductor, the housing, the Antenna
Tuner and the connection cable. The antennas are factory tuned to an impedance of 50 in a
magnetically neutral environment at a distance of 95 cm (37”). When installed in different
ambient conditions, the antenna can be retuned using the DATuningTool program. Once
tuned, the antennas retain their settings as long as the ambient conditions remain
unchanged.