User's Manual
Table Of Contents
- Statements
- Table of Contents
- ILS Open Plus Exit Antenna Installation
- Requirements
- Overview
- Safety Instructions - Read Before Beginning
- Gate Features
- Site Survey
- Disassemble the Gates
- Install the Gate Base
- Connecting the Alarm Kit to the Serial-to-Ethernet Board
- Install the Antenna Body
- Install the Cover Plates
- Antenna Configuration
- Testing the Gate Antenna
- Technical Data
- Appendix
ILS Open Plus Exit Antenna Installation: Appendix 1-27
** Qty. 2 ID ISC.ANT1400/760 antennas, antenna spacing (antenna center), same flow
direction, Tag 46 mm x 75 mm (1.8” x 3”), sensitivity / minimum field strength Hmin=80
mA/m rms, transmitting power 8 W, tag orientation parallel to antenna for horizontal
movement through the antenna.
*** Tag 46 mm x 75 mm (1.8” x 3”), sensitivity / minimum field strength Hmin=80 mA/
m rms, transmitting power 8 W, aligned in all 3 dimensions for horizontal movement
through the antenna.
**** Electrical data refer only to the antenna with tuning circuit.
Appendix
The following section can be used for troubleshooting to ensure the correct parameters are
set.
Reader Configuration Settings
Verify the following settings are configured for the operating power, transponder and ISO
Host Mode:
1 Connect a laptop to the reader on the gate:
a Disconnect RJ45 cable between the reader and serial-to-ethernet board at the serial
port.
b Plug the Checkpoint RJ45-to-DB9 cable adapter into the serial-to-ethernet board.
c Connect a serial cable from the RJ45-to-DB9 cable adapter to the laptop’s serial
port.
2 Launch ISOStart Software.
3 Click Configuration.
Permissible overall transmitting power per
antenna gate
• EU-territory (per EN 300 330)
• USA (per. FCC Part 15)
10.0 W
8.0 W
• Operating frequency 13.56 MHz
Ranges / pass-through width in gate Type -B
and -C
• One tag orientation
• All tag orientations
approx. 115 cm** (45”)
approx. 95 cm*** (37”)
Antenna connection 1 x SMA plug (50 Ω)
Antennac connector cable RG58, 50 Ω, approx. 2 m long (6.6 ft)
Table 1.2
Electrical Data****
Type Description