User's Manual

ILS Open Plus Exit Antenna Installation: Antenna Configuration 1-21
Antenna Board Configuration
Master and Slave antennas must be set as follows (JP3 is factory set to closed and must be
opened). Verify these settings:
Figure 1.21 Antenna Board jumper position
Reader Configuration
To configure the antennas, use the IDReaderConfigurator program to perform the
configuration. You also need the exit antenna configuration files on your computer so that
you can upload the *.xml settings file to the exit antenna.
1 Connect a laptop to the reader on the gate:
a Disconnect RJ45 cable between the reader and serial-to-ethernet board at the serial
port.
b Plug the Checkpoint RJ45-to-DB9 cable adapter into the serial-to-ethernet board.
c Connect a serial cable from the RJ45-to-DB9 cable adapter to the laptop’s serial
port.
2 Launch IDReaderConfigurator.exe program from your computer.
3 Select Manual Mode and click Next.
4 Select the COM port your computer is using.
5 Verify 255 is listed in the BusAdr field.
6 Click Detect to verify your connection.
a If nothing appears, try changing the COM port.
b If that does not work, try a 0 in the BusAdr field if connecting to a Slimline reader
or 9 if connecting to an exit antenna.
7 Once detected, click Next.
8 Click Select Path and browse to the exit antenna configuration files.
Table 1.1 Antenna Board Configuration
Function Jumper Position
1 Ω Q resistor JP1 open
2 Ω Q resistor JP2 closed
Antenna switch JP3 open
JP1
JP2
JP3