User's Manual
Table Of Contents
- Statements
- Table of Contents
- ILS Open Plus Exit Antenna Installation
- Requirements
- Overview
- Safety Instructions - Read Before Beginning
- Gate Features
- Site Survey
- Disassemble the Gates
- Install the Gate Base
- Connecting the Alarm Kit to the Serial-to-Ethernet Board
- Install the Antenna Body
- Install the Cover Plates
- Antenna Configuration
- Testing the Gate Antenna
- Technical Data
- Appendix
1-20 ILS Open Plus 3.0 Installation Manual
possible (routed along the bottom of the board housing at the base of the gate). The cables
must never be allowed to contact the copper tube.
Setting the Multiplexer
By configuring the S1 DIP Switch settings as shown below, all multiplexer settings are
controlled by software. Jumpers are not required.
Figure 1.20
Multiplexer DIP-Switch and Jumper Positions
DIP Switch Configuration
The DIP switch should be configured as indicated in the following table:
Table 1.1
DIP Switch S1
1 2 3 4 5 6 7 8
ON OFF OFF ON