User's Manual
Table Of Contents
- Statements
- Table of Contents
- ILS Open Plus Exit Antenna Installation
- Requirements
- Overview
- Safety Instructions - Read Before Beginning
- Gate Features
- Site Survey
- Disassemble the Gates
- Install the Gate Base
- Connecting the Alarm Kit to the Serial-to-Ethernet Board
- Install the Antenna Body
- Install the Cover Plates
- Antenna Configuration
- Testing the Gate Antenna
- Technical Data
- Appendix
1-18 ILS Open Plus 3.0 Installation Manual
4 Use the mounting bolts to attach the side molding pieces. The positions of the
attachments are shown below.
Figure 1.18
Mounting bolts for frame side sections
Antenna Configuration
The standard configuration of a gate with three-dimensional tag orientation consists of a
master gate and one or two slave gates.
The configuration ensures that if a tag moves through the gate horizontally, it can be read
at least once, ensuring a high reliability of the antenna system.
Configuration and Setup
Required Components
To construct the gate you need the following components:
• Qty. 1 Master Gate (with Reader and Mutiplexer)
• Qty. 1 or 2 Slave Gates
• Power cable, interface cable and connection cable for the DC power supply (2-wire,
twisted)
• Mounting materials (screws, anchors)
• RJ45-to-DB9 Serial Adapter (for connecting technician’s computer to the gate)
To configure and troubleshoot the Reader you need the program:
• IDReaderConfigurator
and for tuning the antennas, the program:
• DATuningTool Version 1.00 or higher
Bottom mounting bolts
Top mounting bolts here
Side molding