User's Manual
Table Of Contents
- Statements
- Table of Contents
- ILS Open Plus Exit Antenna Installation
- Requirements
- Overview
- Safety Instructions - Read Before Beginning
- Gate Features
- Site Survey
- Disassemble the Gates
- Install the Gate Base
- Connecting the Alarm Kit to the Serial-to-Ethernet Board
- Install the Antenna Body
- Install the Cover Plates
- Antenna Configuration
- Testing the Gate Antenna
- Technical Data
- Appendix
ILS Open Plus Exit Antenna Installation: Install the Cover Plates 1-17
1 The diagram above shows the cover plates (5) and (6) as well as the frame side sections
(7). The upper frame section is already sitting on the antenna body as described in
“Install the Antenna Body” on page 1-14.
Figure 1.16
Cover plate in antenna base
2
Insert cover plates in the antenna base and upper frame section as shown below. The
cover plates with the painted, non-transparent section belong on the open side of the
antenna body. This covers the antenna conductors and electronics.
Figure 1.17
Sliding the frame side sections down
3
Plug the side molding pieces in to the antenna body from the side and slide them down.
Start inserting with the bottom key first, then the middle, then the top key.
Cover plate inserted into sill of
base.
Key slides
into there