User's Manual
Table Of Contents
- Statements
- Table of Contents
- ILS Open Plus Exit Antenna Installation
- Requirements
- Overview
- Safety Instructions - Read Before Beginning
- Gate Features
- Site Survey
- Disassemble the Gates
- Install the Gate Base
- Connecting the Alarm Kit to the Serial-to-Ethernet Board
- Install the Antenna Body
- Install the Cover Plates
- Antenna Configuration
- Testing the Gate Antenna
- Technical Data
- Appendix
ILS Open Plus Exit Antenna Installation: Install the Antenna Body 1-15
4 Connect the Alarm Kit components as described in “Connecting the Alarm Kit to the
Serial-to-Ethernet Board” on page 1-12.
Cable Routing Guideline
The cables should be routed as compactly as possible regardless of the antenna
configuration. The cables should be tied into small loops at the end by binding all cables
as far from the antenna conductor as possible. The cables must never be allowed to contact
the copper tube. The antenna cables have a fixed length of approximately 2.10 m or 3.60
m (6.9 ft or 11.8 ft) and may not be shortened.
Figure 1.14
Cable Wrapping in Antenna Base
The above picture shows a correct cable routing.
Cables are dogbone wrapped and routed along the bottom