User's Manual

ILS Open Plus Exit Antenna Installation: Install the Gate Base 1-11
be selected such that they extend at least 45 mm (1.8”) and a maximum of 65 mm (2.6”)
from the floor.
Mounting fasteners are provided by the installer, dependent upon floor type.
Mounting Instructions
Please follow the mounting instructions of the anchor manufacturer for drilling holes
that match the type of flooring.
Cable Routing
Two cable openings are provided for the necessary connection cable. See “Floor Plate
Dimensions” on page 1-10. The cable openings are designed so that up to 10 cables having
a diameter of 6 mm (.24”) can be passed through each opening.
Figure 1.9
Cable Routing
1
Thread the Antenna’s Tuning board cable from each slave gate to the master gate.
2 It is recommended to route the antenna cables through the cable opening on the
Multiplexer side. All other cables such as the supply voltage and multiplexing cable
should be routed through the cable opening on the Reader side.
If the cable openings are not present, the cables can be routed through the cutouts
provided in the antenna base. The cutouts are shown above.
Cutout for cable routing
Floor plate