User's Manual
Table Of Contents
- Statements
- Table of Contents
- ILS Open Plus Exit Antenna Installation
- Requirements
- Overview
- Safety Instructions - Read Before Beginning
- Gate Features
- Site Survey
- Disassemble the Gates
- Install the Gate Base
- Connecting the Alarm Kit to the Serial-to-Ethernet Board
- Install the Antenna Body
- Install the Cover Plates
- Antenna Configuration
- Testing the Gate Antenna
- Technical Data
- Appendix
ILS Open Plus Exit Antenna Installation: Disassemble the Gates 1-9
Note: Only perform the next step if disassembling a master gate.
If disassembling a master gate, unscrew the antenna cable from the multiplexer and
signal LED cable from the serial-to-ethernet board.
Figure 1.7
Antenna removed from base
8
Separate the base from the upper antenna structure, by sliding the two apart.
9 Separate the very bottom floor mounting plate from the base (electronics bay). The
floor mounting plate will be used as a template for the location of the mounting holes
and wire access holes. Discard any screws used for shipping.
Antenna cable
connected to
multiplexer
Signal LED cable connected to serial-to-ethernet board
Antenna partially
removed from base
Nut removed from
screw (not seen) here