User's Manual
Table Of Contents
- Statements
- Table of Contents
- ILS Open Plus Exit Antenna Installation
- Requirements
- Overview
- Safety Instructions - Read Before Beginning
- Gate Features
- Site Survey
- Disassemble the Gates
- Install the Gate Base
- Connecting the Alarm Kit to the Serial-to-Ethernet Board
- Install the Antenna Body
- Install the Cover Plates
- Antenna Configuration
- Testing the Gate Antenna
- Technical Data
- Appendix
1-8 ILS Open Plus 3.0 Installation Manual
Figure 1.5
Top molding removal
5
Remove the top molding only after the side moldings have been removed.
6 Remove the lexan cover plates from the front and back of the gate by lifting out the lip
from the base.
Figure 1.6
Slave gate base
7
Remove the (17mm) nuts and washers at base of the upper antenna structure (inside of
base).
Lift top molding
away
Remove nuts here