User's Manual

4-22 ILS Open Plus 3.0 Installation Manual
Scanning for Inventory
There are several ways to view information on the Search Mode window.
• View 1 - Items Found
Indicates all of the barcodes that were found.
• View 2 - Items Not Found
Indicates all of the barcodes that the system has not yet found.
• View 3 - Show All Items
Shows both the Items Found and the Items Not Yet Found. This is the default
selection.
• Alerts Enabled
When the Alerts enabled is selected, an alert displays and sound occurs for each
item found. The search mechanism stops temporarily, allowing you to locate the
item found on the shelf. To disable this feature, tap it.
1 Tap a different view at any time to change.
2 Use the inventory wand to scan for barcodes, sweeping back and forth. See “Scanning
Books” on page 4-14 for a details.
Notice that the barcode display field(s) reflects changes in the status of the search
items, depending on the search option you chose. Items found (the field above) are
listed as you find them. Items not found (the field below) are removed from the list as
you find them.
Figure 4.29 Item Search window
Notice that the red light on the wand flickers when it finds circulation circuits. It is
important to keep the wand focused on the intended inventory items to avoid unwanted
data from being collected.