User's Manual

4-4 ILS Open Plus 3.0 Installation Manual
There is an LED indicator on the battery charger that indicates when the battery is
completely charged.
5 When charging completes, disconnect the power plug. Insert the front of the battery
(with the tab) first into the wand’s battery receptacle, then rotate the back of battery
down until it clicks into place.
Maintaining the Portable Data Terminal
This section details how to charge and turn on and off the portable data terminal.
Charging the Portable Data Terminal
Before using your terminal for the first time, charge the battery fully using the CRD 2800
cradle or synchronization cable. Your terminal is equipped with a memory backup battery
that automatically charges from the main lithium-ion battery. This backup battery retains
data in memory when the terminal's battery is removed, and takes several hours to charge
when you first use your terminal.
Note: If you remove your lithium-ion battery before the backup battery is fully charged, data may be lost.
For this reason DO NOT remove the battery within the first ten hours of use.
When battery voltage is low, a warning message displays indicating the battery needs to
be charged.
There are two methods to charging the PDT:
1 Using the Serial Charging Cable
2 Using the Universal Cable Cup
Using the Serial Charging Cable to charge the battery
1 Insert the cable into the bottom of the terminal.
Figure 4.5 Insert Synchronization Cable
*
.
Serial Charging
Cable