User's Manual

3-10 ILS Open Plus 3.0 Installation Manual
4 Pull the paper out a bit, as seen below in Figure 3.12, “Lower the Paper Guide.”
Figure 3.12 Lower the Paper Guide
5
Rotate the paper guide back down until you position the guide in between the main roll
and the paper fed underneath the paper guide.
6 Once the paper guide clicks into place, the paper cutter should activate and partially cut
the paper. If not, then reseat the paper guide again. If the cutter still fails to activate,
reboot the Self-Checkout Station and try again.
Powering On the Self-Checkout Station
The following procedure powers on a Self-Checkout Station:
Figure 3.13 Turning On the Self-Checkout Station
1
On the back panel of the Self-Checkout Station, flip on the power switch.
2 The Self-Checkout Station starts, logs in, and launches the CheckPC program
automatically.
Power On/Off Switch