User's Manual
Table Of Contents
- Table of Contents
- Introduction
- Application Server
- Patron Self-Checkout Station
- Portable Inventory Reader
- ILS Remote Monitor
- Exception Ticket Printer
- CheckVIEW
- Affixing Tags
- Using Tag Programming Station
- Using DiscMate
- CheckPASS
- Troubleshooting Guide
- System Maintenance
Affixing Tags: Applying tags to CDs and DVDs 8-7
To place tags on DiscMate DVD cases
This procedure only applies to DVD cases. To place standard 2" x 2" tags on DiscMate
DVD (single or double) cases:
1 If necessary, unlock the case.
2 Open the DVD case.
3 Peel the backing from the tag.
Figure 8.8
Sample Placement of Label on a CD/DVD Case
4
On the inside the front of the case, place the tag into the very top right corner, as close
to the spine and top of the case as possible. Make sure that the dot is farther away from
the spine and top of the case, as seen above.
5 If desired, affix a library cover-label sticker over the tag.
Note When re-inserting DVD covers, do not use original artwork that is made of cardboard weight stock.
The thicker cover may not allow the DiscMate case to slide through the DiscMate opening properly,
due to the material’s thickness. Original artwork should be scanned or copied onto regular (20 lb.)
paper stock before putting under the dust jacket.
Dot