User's Manual

6-6 ILS Open Plus 3.0 Installation Manual
Running a Self-Test
Follow these steps to run a self-test on the paper roll:
1 Be sure that the printer is off and that the printer cover is closed properly.
2 Hold down the Feed button and turn on the printer using the switch on the front of the
printer. This may take some time, so continue holding the Feed button until it prints.
3 The self-test prints the printer settings and then prints the following:
If you want to continue SELF-TEST printing,
Please press the PAPER FEED button.
Cuts the paper, and pauses. (The Power Out light flashes.)
4 Press the Feed button to continue printing. The printer prints a pattern using the
built-in character set.
5 The self-test automatically ends and cuts the paper after printing “ *** completed *** .”
The printer is ready to receive data as soon as it completes the self-test.
Note: To pause the self-test manually, press the Feed button. Press Feed again to continue the self-test.
Installing the Cover
There are two covers that can be used to protect the printer from unnecessary interaction: a
power switch cover and a connector cover. Using these covers are optional, depending
upon the needs of the library.
Installing a Power Switch Cover
Warning If an accident occurs with the power switch cover attached, unplug the power cord immediately.
Continued use may cause fire or shock.
The enclosed power switch cover ensures that the power switch is
not pressed accidentally. To use this cover:
1 Insert the lower end of the cover into the slot around the switch.
2 Rotate the cover upwards until it snaps into place.
3 To remove the cover, use a flat bladed screwdriver to lever the
cover off.
Installing a Connector Cover
The connector cover protects your cables. To attach it:
1 First, connect all the cables. The connector cover has three possible
cable exits: on the right, left, and back. Remove the tab for the exit
you want to use by breaking it off with your fingers.
Note: Once you remove a tab, you cannot replace it.
2 After removing the tab, also remove any protruding plastic, so that the edge is smooth
and does not damage the cables.
E
R
R
O
R
P
O
W
E
R
P
A
P
E
R
O
U
T
F
E
E
D