User's Manual

System Maintenance Guide
Page 7-2 Intelligent Library System (ILS) 2.0 User Manual
2. In order to logon as Administrator, the Autolog program must be disabled. Select
Run from the Start menu.
3. Enter Autolog.
4. Select Disable Autolog and press OK.
5. Select Shutdown from the Start menu.
6. Select Close All Programs and Log on as a Different User. Press OK.
7. Log on as Administrator.
8. The ILS Server will automatically launch. Wait for it to complete and then shut down
the program again.
9. Launch the Windows NT backup program. It is located in the Start menu under
Programs / Administrative Tools.
10. In the Drives window, select the drive that you want to back up.
11. On the Select menu, click Check.
12. On the Operations menu, click Backup.
13. When the backup is complete logoff, then log back on as RFIDSRV. Once logged
back in enable the Autolog process (refer to steps 2-4 above) by entering the
appropriate password and selecting Enable Auto Logon.
Restore
1. Follow steps 1 through 9 from the backup instructions.
2. To restore individual files in a backup set on a tape: in the Tapes window, load the
catalog of the backup set from which you want to restore certain files.
3. Select all the files you want to restore using the appropriate method:
4. To select contiguous files, click the first filename, hold down SHIFT, and click the
last contiguous filename.
5. To select non-contiguous files, click a filename, hold down CTRL, and click each
filename.
6. On the Select menu, click Check. A check mark displays in the check box for each
selected file.
7. On the Operations menu, click Restore.