User's Manual

Tagging Procedures
Figure 5-4: Tagging CD Materials with Preprogrammed Circulation Circuit
5.4. Tagging CD Materials with Circulation Circuit
grammed On-Site Pro
rogrammed On-Site, use the following
plain cover label in the lower
ial with
5.5. Tagging Audio Materials
When ta
The preferre nside front cover, centered horizontally
and vertically.
. For audio cases that contain tapes on both inside sections of the audio case. Remove
the card stock from the outside sleeve of the front cover.
Attach the circulation circuit in the sleeve and replace the card stock
If the card stock is metallic, photocopy and replace the card stock.
Your cover labels options are as follows:
When tagging CD Material with Circulation Circuit P
steps:
1. Disassemble CD and place the circulation circuit with
right corner
2. Reassemble CD
Your cover label options are plain and the recommended application is mater
existing barcode labels.
gging Audio Materials, use the following steps:
d location for the circulation circuit is on the i
1
2.
3.
Intelligent Library System (ILS) 2.0 User Manual Page 5-3