User`s guide

©Microcontroller-café & Checkpoint LAB M35160 ERASER/PROGRAMMER User’s Guide
14
6. Press “RS” button for initialization hardware before erase function
7. Press “WR” button to start erase procedure
8. Numeric display will change one by one numbers of incremental registers
recovered to factory settings already:
“ AU“
 “ P1“  “ P2“  ” 01”  ” 02”………  ” 15”  ” 16”  “ --“
9. In the end of erase procedure you’ll see on the numeric display message: “ --“
4.6 TEST READ (Blank check) : AU mode start
Test read function will check first 32 byte page.
If the data equal to zeros the numeric display will return message: “ oo“ .
If the data is not equal to zeros the numeric display will return message: “ EE“
1. Mode jumper mounted to “ AU“ position (Figure 2)
2. “Function” jumper must be mounted to any position 160/TST/080
for test read (blank check) function
3. Press RS button
4. Press RD button
5. Check result message on the numeric display. “ oo“ : first 32 bytes is 0x00,
from now device is blank.
Figure 17
Status message -->
Press RS button
Press RD button
Function
j
um
p
er
Step 2
Step 3
Step 4