User guide
– 10 –
4.4 Pro Mode
Follow the steps below to access the pro mode:
1. Turn the selector switch (E) from OFF to the required position while
simultaneously holding the rotary/push knob (D) until the PRO notication
appears in the display.
2. When the Pro mode is activated, a P appears in the bottom right area of the display
NOTE: If you have selected settings in Pro Mode and then switch the device off, these
settings will ONLY be active when the device is switch back on if pro mode is activated.
Otherwise, only the standard mode settings will be active.
No. Position of the
Selector Switch
(E)
Adjustable
Parameters
Description Display
(4) FREQUENCY FPM Description: Frequency selection; FPM:
ashes per minute
- Turning the knob while pushing
it simultaneously, the adjustment
increment is effected in steps of 100.
- The ash can be turned off by
pushing the knob once and turned on
again by pushing the knob once again.
(1) BRIGHT BRIGHT deg Selection of brightness
(in 1/1,000 degrees)
(3) MENU PHASE deg:
0…359
Delay setting between the trigger signal
and ash (in degrees relative to the
frequency
(10) MENU INT /EXT Internal /external trigger
NOTE: See also section 4.3 Standard Mode for examples and explanation regarding the above mentioned
display messages.