Manual

314
DIMENSIONS
MX2-110
71
(2.79")
220
(8.66")
200
(7.87")
380
(14.9")
562
(22.1")
110
(4.33")
0~240
(0~9.44")
M6
12
(.47")
100
(7.87")
60
(2.36")
M8
100
(3.93")
DIGITAL FORCE GAUGE
00.0
NG
Lb
OK +NG
OVERLOAD
ZERO
SEND PEAK
ON
OFF
Select
Enter
Back
Changing Speed Units
1. Press the Back button to
change to Cycle Mode.
2. Press and hold the dial until the
Config Mode screen appears.
3. Turn the dial until Extra Config
appears (arrows
<>indicate
current selection).
4. Press the dial to enter Extra
Config Mode.
5. Turn the dial in Extra Config
Mode until Unit Select appears.
6. Press the dial to enter.
7. Turn the dial to select inch or
millimeter.
8. Press the Back button twice to
exit Extra Config Mode and return
to Cycle Mode. Unit selection is
then retained in memory for
future tests.
5
Check the following before testing
1. Turn the Emergency Stop clockwise to make sure it is
released. Press it whenever you are in an emergency situation.
2. Move the Upper and Lower Travel Limits so that there is
separation between them or the cross head will not move and
and a limit error is displayed on the LCD screen (see page 5).
3. Connect the power cord to the proper AC power.
4. Turn on power switch on the back of the test stand.
When the power is turned on Manual
Mode/Speed Adjust is the startup
screen. The default speed unit is
mm/min.
6
7
MANUAL MODE
5.50 mm/min
# SPEED ADJUST
CONFIG MODE
< EXTRA CONFIG >
ENTER EXTRA CONFIG
EXTRA CONFIG MODE
UNIT SELECT
< INCH