User guide

15
Error message 1:
- The DISPLAY shows
EEE
.
The upper limit of the tension range was exceeded by more than 10%.
Reduce the line tension
OR
AUTO ZERO is no longer possible.
Recalibrate the instrument following the directions in Chapter 3.7.1.
Error message 2:
- The DISPLAY shows .
The lower limit of the tension range was fallen below by more than 10%.
Properly insert the process material
OR
AUTO ZERO is no longer possible.
Recalibrate the instrument following the directions in Chapter 3.7.1.
Error message 3:
- The DISPLAY shows
6
CN
– +
.
The battery is low and must be replaced immediately. Operating the tension meter with
a low battery may cause measurement errors.
3.5 Error Messages