Instruction Manual

Sensor Selection Guide
Model
Description
Product subject to change without notice.
DIMENSIONS
SUPPLY VOLTAGE
10 to 30 VDC
Polarity Protected
CURRENT REQUIREMENTS
45 milliamps (exclusive of load)
OUTPUT TRANSISTORS
(1) NPN and (1) PNP output transistors
Sensor outputs can sink or source up to 150 milliamps
(current limit)
All outputs are continuously short-circuit protected
REMOTE AUTOSET™ INPUT
Opto isolated momentary sinking input (10 milliamps)
RESPONSE TIME
Light state response = 100 microseconds
Dark state response = 100 microseconds
LED LIGHT SOURCE
Pulse modulated high intensity white LED
PUSHBUTTON CONTROL
One pushbutton set-up
Automatic set-up routines based on web opacity
Simultaneously pushing both buttons inverts the output
On power-up, simultaneously pushing both buttons enables
the program mode, allowing the pulse stretcher to be
enabled or disabled
SPECIFICATIONS
HYSTERESIS
Minimal hysteresis promotes detection of low contrast
registration marks
LIGHT IMMUNITY
Responds to sensor’s pulse modulated light source …
immune to most ambient light
INDICATORS
Green AUTOSET™ LED flashes when AUTOSET™ routine is
activated and stays illuminated when AUTOSET™ is completed
Red Output LED illuminates when sensor’s output
transistors are “ON”
On power-up, the AUTOSET™ LED flashes twice when
the pulse stretcher is enabled
AMBIENT TEMPERATURE
- 40°C to 70°C (- 40°F to 158°F)
RUGGED CONSTRUCTION
Chemical resistance to harsh cleaners, such as
detergents, alcohols, and ketones
Waterproof ratings: NEMA 4 and IP66
Conforms to heavy industry grade CE and UL requirements
SELECTABLE PULSE STRETCHER
Provides a minimum of 10 milliseconds output duration
MEWL White LED, 5-conductor cable
MEWLC White LED, 5-
pin
micro
connector on a 6” pigtail
Cable Selection Guide (5 Wire)
Model
Micro Cable (M12) Description
GSEC-2MU 6.5 ft. (2.0m) Low Cost, Unshielded
GSEC-5MU 16 ft. (5.0m) Low Cost, Unshielded
GSEC-6 6 ft. (1.8m) Shielded Cable
GSEC-15 15 ft. (4.6m) Shielded Cable
GPSEC-15 15 ft. (4.6m) Shielded Cable
CHECK
LINE
®
–PRECISION QUALITY CONTROL I NSTRUMENTS
Electromatic Equipment Co., Inc.
600 Oakland Ave.
Cedarhurst, N Y 11516 —USA
Tel: (800) 645-4330 (USA & Canada)
Tel: (516) 295-4300
Fax: (516) 295-4399
Email: info@checkline.com
Website: www.checkline.com