Owner manual

– 6 –
5.0 Connection


uses and labelling of these sockets are as follows:
Marking: 1

Marking: 2

Marking: Output

The assignment of plug contacts is shown in Fig 1 below..
• Please make the connections in accordance with the wiring diagram
(Fig. 1). The trigger input is potential-free. The potential-free input
is suitable for PNP and NPN signals. A matching plug for these input
sockets is included with the LS-5-LED.
 
RECOMMENDATION!
Use a shielded cable to connect the trigger signal.
–7 –
5.1 Typical connection examples:
Please take connection examples from Figures 2 to 5. Please note that you will need
optional accessories for some of the examples (stroboscope control unit, AC Adapter,
sensor).
 
from external equipment (Fig. 2).
B. Trigger signal from external
equipment (Fig. 3), supply
 
C. Trigger signal from optional
 
for unit and sensor from optional
AC Adapter.