Model ESMH MOTORIZED FORCE MEASUREMENT TEST STAND User’s Guide
Model ESMH Motorized Test Stand User’s Guide Thanks! FORCE GAUGES BY MARK-10 Thank you for purchasing a Mark-10 Model ESMH motorized test stand. We are confident that you will get many years of great service from this product. Capacities from 0.12 lb (0.5 N) to 1,000 lb (5,000 N) Mark-10 test stands and load frames are ruggedly built for many years of service in laboratory and industrial environments.
Model ESMH Motorized Test Stand User’s Guide TEST STANDS BY MARK-10 INTRODUCTION Manual and motorized, up to 1,000 lb and 100 lbin The ESMH motorized test stand is a horizontal force measurement tester designed to test up to 50 lb [250 N] of tensile or compressive force. The ESMH works in conjunction with a force gauge and gripping fixtures. Common applications include peel testing, small spring testing, coefficient of friction testing, and other product performance testing.
Model ESMH Motorized Test Stand SAFETY TIPS ■ ■ User’s Guide DIMENSIONS IN [MM] Wear eye and face protection when testing. Although the ESMH has relatively slow moving mechanisms, be aware of the dangers posed by potential energy that can accumulate in a sample during testing. OPTIONAL TRAVEL DISPLAY 2.00 [50.7] Keep away from the moving parts of the test stand. 2.23 [56.6] 7.25 [184.1] ■ Never operate the test stand if there is any visible damage to the power cord or the control unit.
Model ESMH Motorized Test Stand User’s Guide Mounting force gauges About the digital travel display (optional) To mount a force gauge, it is necessary to temporarily remove the gauge adapter from the crosshead. Loosen the two 5/16 screws (shown at left) using the included tool kit. Then, mount the gauge to the adapter using the four included gauge mounting screws. After the gauge is mounted to the adapter, mount the adapter back onto the crosshead with the 5/16 screws.
Model ESMH Motorized Test Stand User’s Guide OPERATION Powering up Using the controller Plug the power cord into the controller and the other end into a wall outlet. Then turn on power with the power switch (see Page 5). Rear View Top View Reading the indicators 4 7 POWER Power is indicated by an illuminated indicator. 1 2 4 7 5 3 6 1. SPEED CONTROL DIAL Adjust speed by turning the dial 0.2 – 50.0 in/min [5 – 1270 mm/min]. 2.
