Force Test Stands Series ES MODELS ESM & ES30 U se r’s Guide
Models ESM & ES30 Thanks! Thank you for purchasing a Mark-10 Series ES Force Measurement Test Stand. We are confident that you will get many years of great service from this product. Mark-10 test stands are ruggedly built for many years of service in laboratory and industrial environments. This User’s Guide provides unpacking, setup, and operator instructions for the Model ES30 and Model ESM Force Measurement Test Stands. Dimensions and specifications are also provided.
Models ESM & ES30 User’s Guide OTHER TEST STANDS BY MARK-10 LIST OF INCLUDED ITEMS Manual and motorized, up to 1,000 lb and 100 lbin Quantity TSAH Manual, Force Lever 750 lb TSB Manual, Force Lever 100 lb TSF Manual, Force Hand wheel 1,000 lb TSTM Motorized, Torque 100 lbin ES10 Manual, Force Lever 100 lb Force measurement test stand 1 Remote console (ESM, only) 1 Power cord (ESM, only) 1 User’s guide (this booklet) 4 Thumb screws for gauge mounting 1 Mounting hole drill template 1 Acce
Models ESM & ES30 User’s Guide ESM SAFETY TIPS • Wear eye and face protection when testing. Although the ESM has relatively slow moving mechanisms, be aware of the dangers posed by potential energies that can accumulate in the sample during testing. • Keep away from the moving parts of the test stand. • Never operate the test stand if there is any visible damage to the power cord or the control unit. The ESM is powered by 110/220 volts that are present in both the power cord and the control unit.
Models ESM & ES30 User’s Guide ES30 OPERATION Place the stand on a clean, flat, and level surface. It is recommended that the stand be mounted to the surface with two 5/16 screws. Use the mounting hole drill template for quick setup. Install a force gauge onto the gauge plate with four thumb screws. All Mark-10 force gauges (except the Series CG) mount directly to the stand without adapters.
Models ESM & ES30 User’s Guide ESM ESM DIMENSIONS Using the Control Unit UP Press and hold for tension, release button to stop motion. Located on the face of the Control Unit. DOWN Press and hold for compression, release button to stop motion. Located on the face of the Control Unit. SPEED CONTROL DIAL Adjust speed by turning the dial 0.5 – 13 in/min [13 – 330 mm/min]. Located on the face of the Control Unit.
