User guide

5
Set-Up
Power
Refer to diagram 1 (right) for location of the terminals.
AC Models
Apply 85 – 264 VAC, 50/60 Hz between terminals 1 and 2.
DC Models
Apply 9 –35 VDC between terminals 1 (positive) and 2
(negative) on the main terminal block.
After proper power (AC or DC) is applied to the unit
and before any sensor is connected, the LED display
will light up.
Sensor Connection
Use the chart below to determine how to connect the
DT-5TXR/DT-5TS to Shimpo sensors:
diagram 1
Self-Test
To confirm that all display LEDs are operating correctly, a self-test is recommended (see “Display and Keypad” section
for button locations):
1. Press and hold the MODE button for approximately 3 seconds; “0” will begin flashing until “-01-” appears on the
display.
2. Press any of the lower buttons (NUMERIC, NEGATIVE SIGN/DECIMAL POINT, BACKSPACE) to scroll through “-02-”,
“-03-” and “-04-” until “-99-” appears on the display.
3. Press the SET button to begin the self-test. The entire display will cycle through all digits, arrows, dashes, colons,
decimal points, etc.
4. When satisfied that all LED’s are operational, press the SET button to exit.
SENSOR
TYPE
TERMINAL NUMBER FREQUENCY or RPM RANGE OPERATION TEMPERATURE FILTER
MPR 000,5 – 0C06-B1ER
3 – 0C006-B1ER ,000 RPM
1 – 0C0001-B1ER ,800 RPM
zHk 001)C°9.84+ - °03-( F°021+ - °22-zH 052 – 0526-SCM
F°131+ - F°31-zH 333 – 0556-SCM
(
-25° - +55°C
)
100 kHz
MP-10 -40° - +221°F
(
-40° - +105°C
)
3030AN -100° - +225°F (-73° - +107°C)
3070A* -100° - +200°F (-73° - +104°C)
Contact Closure Relay or Solenoid Jumper 5 and 6 Connect 6, zH 02zH 02<9
BI2-S12 Open Collector NPN Proximity 4,6, F°851+ - °31-zHk 2 – 09 (-25° - +70°C) 100 kHz
zHk 03)C°07+ - C°02-( F°851+ - F°4-zHk 8 – 09,7,4ytimixorP gnihctiwS eriw-3G-ES
zHk 01)C°06+ - °55-( F°041+ - °86- zHk 1 – 08,4ytimixorP gnihctiwS noN eriw-2G-2JD
* For hazardous locat ions
10 kHz
Retro-Reflective
Magnetic
Rotary Pulse Generator 30 kHz
3,8,9
)C°05+ - °01-(F°221 - °419,7,4
4,6,9
Rear Panel and Terminals
NO. DESIGNATION
1. Lower Module Latch
2. Upper Module Latch
3. Lower Module Connector
4. Upper Module Terminal Block
5. Rear Cover
6. Main Terminal Block