Technical data

Installing and Removing Hard Disks
Customer Replaceable Parts Page 24
To remove a hard disk
1. Move out the LCD panel and lock the spring-loaded screw into retaining ring.
2. On the hard disk drive, push left on the ejector handle and turn outward.
3. Remove the hard disk drive by pulling on the ejector handle and the hard disk drive bezel. Move the
hard disk drive of the chassis.
To install a hard disk:
1. Insert the hard disk drive into the slot.
2. Turn the ejector handle to the closed position.
3. Press on the hard disk drive until it sits in its connector. To do this, apply pressure, at the same time on
the:
 Right side of the bezel (using your left hand).
 Flat part of the ejector handle (using your right hand).
4. Release the LCD panel: Press the spring-loaded screw to release the panel from the retaining ring.
5. Move the LCD panel to its usual position.
Hard Disk Drives RAID Monitoring
The Check Point 21400 VSX performs RAID1 mirroring across two hard disk drives using software RAID.
This lets the Check Point 21400 VSX continues working in the event of a disk failure.