Technical data

Replacing Hard Disk Drives on Check Point 12200 VSX
Customer Replaceable Parts Page 32
Replacing Hard Disk Drives on Check Point
12200 VSX
This section describes how to remove or install a hard disk drive in a Check Point 12200 VSX appliance.
Removing a Hard Disk Drive
To remove a hard disk drive from a Check Point 12200 VSX:
1. Using the key supplied in the toolkit, unlock the drive.
2. Slide the release latch toward the left. The extraction handle pops out.
3. Using the extraction handle, remove the drive from the slot.
Installing a Hard Disk Drive
To install a hard disk drive in a Check Point 12200 VSX:
1. Slide the replacement hard disk drive into the slot.
2. Push the extraction handle until it closes and the drive clicks into place.
3. Using the key supplied in the toolkit, lock the new drive.