Technical data

Command Line Reference
Check Point VSX Administration Guide NGX R67 | 198
7. When prompted, select the interface to be replaced.
8. When prompted, select the replacement interface.
a) You can optionally add a new interface by selecting "Enter new interface name". This interface
must physically exist on the VSX Gateway or cluster members or the operation will fail.
b) At the prompt, enter the new interface name. If the new interface is a bond, the interface name must
match the bond name exactly (bond names are case sensitive).
9. To replace additional interfaces, enter "y" when prompted and repeat steps 6 through 8.
10. To complete the process, enter "n".
11. If you selected the Apply changes to management only option, run the vsx_util reconfigure
command ("reconfigure" on page 201) to push the updated configuration to the VSX gateways or
cluster members.
12. Reboot the VSX gateway and/or cluster members as appropriate.
Notes
 The Apply changes to management and gateway/cluster members option verifies connectivity
between the management server and the VSX gateway or cluster members. In the event of a
connectivity failure one of the following actions occur:
a) If all of the newly changed interfaces fail to establish connectivity, the process terminates
unsuccessfully.
b) If one or more interfaces successfully establish connectivity, while one or more other interfaces fail,
you may optionally continue the process. In this case those interfaces for which connectivity was
established successfully will be changed. For those interfaces that failed, you must then resolve the
issue and then run the vsx_util reconfigure ("reconfigure" on page 201) command to complete the
process.
 If you select the Apply changes to management Only option, you can select another interface from list
(if any are available) or select the option to add a new interface.
change_mgmt_ip
Description
Changes gateway or cluster member management IP address
Syntax
vsx_util change_mgmt_ip
Input
 VSX gateway/member object name
 New management IP address
Comments
 We recommend that you back up the management database before
using this command.
 Execute the command and follow the instructions on the screen.
change_mgmt_private_net
Description
Changes the cluster internal communication network IP address
Syntax
vsx_util change_private_net
Input
 VSX cluster object name
 New cluster private network: New IP address for the cluster private
network