Technical data

Command Line Reference
Check Point VSX Administration Guide NGX R67 | 192
Report Results
 Required slave interfaces as explained in
|
("Setting Critical Required Interfaces" on page 139).
 The Status column can contain the following values:
 Down (Load Sharing mode only) - the physical link is down.
 Active - currently handling traffic.
 Standby (High Availability mode only) - the interface is ready, and can support internal bond
failover.
 Not Available (High Availability mode only) - either the physical link is broken, or that the Cluster
member is in status down. The bond cannot failover in this state.
 The Link column reports whether the physical link exists.
chpaconf failover_bond
Initiates bond interface failover in the High Availability mode.
Syntax
cphaconf failover_bond <bond-name>
cphaprob -a if
Displays the status of all interface bonds and VLANs. For an HA bond, specifies whether it can failover.
Syntax
cphaprob -a if
Example
[Expert@GW-1]# cphaprob -a if
Required interfaces: 5
Required secured interfaces: 1
bond0 UP non sync(non secured), broadcast, bond, can
failover
bond2 UP sync(secured), multicast, bond Load Sharing
bond1 UP non sync(non secured), multicast, bond Load
Sharing
Virtual cluster interfaces: 4
bond0 192.168.34.60
bond1.60 10.34.60.1
bond1.61 10.34.61.1
bond1.62 10.34.62.1
VSX Resource Control Commands
The following commands work with the VSX Resource Control feature.