Manualshelf

Technical data

ManualsBrandsCheck Point Software Technologies ManualsNetworkingSmart-1 150
21222324252627282930
Using the First Time Configuration Wizard
Network Connections
Configure Network Connections in the Network Connections page.
You may modify the Mgmt IP address and connectivity will be preserved. A secondary interface is created
automatically to preserve connectivity. This interface can be removed after the wizard is completed in the
Network > Network Connections page.
Routing Table
Configure Routing on the Routing Table page.
DNS and Domain Settings
Set the Host, Domain and DNS Servers in the DNS and Domain Settings page.
The host name must start with a letter and cannot be named Com1, Com2, … , Com9.
Management Settings
The remaining screens of the First Time Configuration Wizard are specific to the image you have on the
Smart-1
If Smart-1 has a Security Management server image, continue with the screens in this section.
If Smart-1 has a Multi-Domain Security Management image, continue with the Multi-Domain Security
Management settings (on page 24).
Security Management Installation Type
Note - This page is only available in R75 or higher.