User guide

Using Rapid Deployment
Chapter 23: Maintenance 761
Table 158: Rapid Deployment File Names
This file...
Should be named...
The primary firmware
primary.firm / primary.img
The backup firmware
secondary.firm / secondary.img
The configuration file
embeddedngx.cfg
The default configuration file
preset.cfg
The certificate
embeddedngx.p12
Performing a Rapid Deployment
You must perform the following procedure on each Safe@Office appliance you want to
deploy.
To perform a rapid deployment
1. Reset the Safe@Office appliance to its default settings.
See Resetting the Safe@Office Appliance to Defaults on page 762.
2. Disconnect the Safe@Office appliance from its power adapter.
3. Insert the USB flash drive into the appliance’s USB port.
For information on locating the USB ports, see Introduction on page 1.
4. Reconnect the Embedded NGX appliance to its power adapter.
The following things happen:
• The PWR/SEC LED flashes quickly in green, signaling that rapid deployment
is in progress.
• The file results-<MACAddress>.log is created in the USB flash
drive's root folder, where <MACAddress> is the appliance's MAC address.