User guide

Configuring SNMP
Chapter 23: Maintenance 731
• IP-MIB
All SNMP access is read-only.
Note: Configuring SNMP is equivalent to creating a simple Allow rule, where the
destination is This Gateway. To create more complex rules for SNMP, such as
allowing SNMP connections from multiple IP address ranges, define Allow rules for
the relevant port (by default, TCP port 161), with the destination This Gateway. For
information, see Using Rules on page 400.
To configure SNMP
1. Click Setup in the main menu, and click the Management tab.
The Management page appears.
2. Specify from where SNMP access should be granted.
See Access Options on page 730 for information.
If you selected Internal Networks + IP Range, additional fields appear.
The Community field and the Advanced link are enabled.