User guide

Configuring SNMP
730 Check Point Safe@Office User Guide
Table 151: Access Options
Select this
option…
To allow access from…
Internal Networks The internal network only.
This disables remote access capability. This is the default.
Internal Networks +
VPN
The internal network and your VPN.
Internal Networks +
IP Range
A particular range of IP addresses.
Additional fields appear, in which you can enter the desired IP address
range.
ANY Any IP address.
Disabled Nowhere.
This disables both local and remote access capability.
This option is relevant to the SNMP protocol only.
Configuring SNMP
Safe@Office appliance users can monitor the Safe@Office appliance, using tools that
support SNMP (Simple Network Management Protocol). You can enable users to do so via
the Internet, by configuring remote SNMP access.
The Safe@Office appliance supports the following SNMP MIBs:
• SNMPv2-MIB
• RFC1213-MIB
• IF-MIB