User guide

Using Rules
410 Check Point Safe@Office User Guide
In this field…
Do this…
To specify the Safe@Office IP addresses, select This Gateway.
To specify any destination except the Safe@Office Portal IP addresses,
select ANY.
If the current time
is
Select this option to specify that the rule should be applied only during
certain hours of the day.
You must then use the fields and drop-down lists provided, to specify the
desired time range.
Forward the
connection to
Select the destination to which matching connections should be forwarded.
To specify an IP address, select Specified IP and type the desired IP address
in the text box.
This field only appears when defining an Allow and Forward rule.
Quality of
Service class
Select the QoS class to which you want to assign the specified connections.
If Traffic Shaper is enabled, Traffic Shaper will handle these connections as
specified in the bandwidth policy for the selected QoS class. If Traffic Shaper
is not enabled, this setting is ignored. For information on Traffic Shaper and
QoS classes, see Using Traffic Shaper on page 293.
This drop-down list only appears when defining an Allow rule or an Allow and
Forward rule.
Redirect to port Select this option to redirect the connections to a specific port.
You must then type the desired port in the field provided.
This option is called Port Address Translation (PAT), and is only available
when defining an Allow and Forward rule.