User guide

Configuring Wireless Networks
340 Check Point Safe@Office User Guide
Note: This is the MAC address of the WLAN interface, not the WAN MAC address. To
see your access point's WLAN MAC address, click Reports in the main menu, and
then click Wireless.
7. Do one of the following:
• To create a bridged WDS link:
1) In the Mode drop-down list, select Bridged.
The fields are enabled and additional fields appear.
2) Complete these fields as described in Bridged Network Fields on
page 273.
• To create a routed WDS link, do the following:
1) In the Mode drop-down list, select Enabled.
The fields are enabled.
2) In the IP Address field, type the IP address of the WDS link's default
gateway.
The WDS link must not overlap other networks.
3) In the Subnet Mask field, type the WDS link's internal network range.
8. If desired, enable or disable Hide NAT.
See Enabling/Disabling Hide NAT on page 199.
9. If desired, configure a DHCP server.
See Configuring a DHCP Server on page 200.
10. Complete the fields using the relevant information in Basic Wireless Settings
Fields on page 324.
11. To configure advanced settings, click Show Advanced Settings and complete
the fields using the relevant information in Advanced Wireless Settings Fields
on page 329.