User guide

Adding Internet Connections to Bridges
274 Check Point Safe@Office User Guide
In this field…
Do this…
Spanning Tree Protocol - Port
Priority
Select the port's priority.
The port's priority is combined with the port's logical number to
create the port's ID. The port with the lowest ID is elected as
the root port, which forwards frames out of the bridge. The
other ports in the bridge calculate the least-cost path to the
root port, in order to eliminate loops in the topology and
provide fault tolerance.
To increase the chance of this port being elected as the root
port, select a lower priority.
Note: If you select the same priority for all ports, the root port
will be elected based on the port's logical number.
The default value is 128.
This field only appears if the bridge uses STP.
Adding Internet Connections to Bridges
To add an Internet connection to a bridge
1. Click Network in the main menu, and click the Internet tab.
The Internet page appears.
2. Next to the desired Internet connection, click Edit.
The Internet Setup page appears.
3. In the Port drop-down list, specify the port that the Internet connection should
use, by doing one of the following:
• To use the ADSL port, select ADSL.