User guide

Using Static Routes
244 Check Point Safe@Office User Guide
6. Click Next.
The new static route is saved.
Table 42: Static Route Fields
In this field…
Do this…
Source Specify the source network (source routing). This can be either of the
following:
• ANY. This route applies to packets originating in any network.
• Specified Network. This route applies to packet originating in a
specific network. The Network and Netmask fields appear.
Source - Network Type the source network's IP address.
Source -
Netmask
Select the source network's subnet mask.
Destination Specify the destination network. This can be either of the following:
• ANY. This route applies to packets sent to any network.
• Specified Network. This route applies to packets sent to a specific
network. The Network and Netmask fields appear.
Destination -
Network
Type the destination network's IP address.
Destination -
Netmask
Select the destination network's subnet mask.
Service Specify the service used to send packets (service routing). This can be either
of the following:
• ANY. This route applies to packets sent using any service.
• A specific service or network service object.
Note: When defining a static route for a specific service, the Source and
Destination fields must be set to ANY.