User guide

Appliance Installation
Chapter 3: Installing and Setting Up Safe@Office 101
4. To use the appliance with a non-ADSL connection, or with an existing ADSL
modem, connect an Ethernet cable:
a. Connect one end of the Ethernet cable to the appliance's DMZ/WAN2 port.
b. Connect the other end of the cable to an external cable modem, DSL
modem, or office network.
5. Connect the power adapter to the appliance's power socket, labeled PWR.
6. Plug the power adapter into the wall electrical outlet.
Warning: The Safe@Office appliance power adapter is compatible with either 100,
120 or 230 VAC input power. Verify that the wall outlet voltage is compatible with the
voltage specified on your power adapter. Failure to observe this warning may result
in injuries or damage to equipment.
Figure 23: Typical Connection Diagram