User guide

Appliance Installation
Chapter 3: Installing and Setting Up Safe@Office 99
Appliance Installation
Installing Non-ADSL Models
To install the Safe@Office appliance
1. Verify that you have the correct cable type.
For information, see Network Requirements on page 61.
2. Connect the LAN cable:
a. Connect one end of the Ethernet cable to one of the appliance's LAN
ports.
b. Connect the other end to PCs, hubs, or other network devices.
3. Connect the WAN cable:
a) Connect one end of an Ethernet cable to the appliance's Ethernet WAN
port.
a. Connect the other end of the cable to a cable modem, DSL modem, or
office network.
4. Connect the power adapter to the appliance's power socket, labeled PWR.
5. Plug the power adapter into the wall electrical outlet.
Warning: The Safe@Office appliance power adapter is compatible with either 100,
120 or 230 VAC input power. Verify that the wall outlet voltage is compatible with the
voltage specified on your power adapter. Failure to observe this warning may result
in injuries or damage to equipment.