Technical data

Page 14
Chapter 3
Configuring Check Point 4000
Appliances
The workflow for configuring Check Point 4000 Appliances is:
1. Connect the cables and power on the appliance.
2. Use the First Time Configuration Wizard to configure the appliance.
3. Add the Check Point 4000 Appliances object in SmartDashboard and install a policy.
In This Chapter
Powering On 14
Using the First Time Configuration Wizard 15
Creating the Network Object 18
Advanced Configuration 18
Powering On
To power on Check Point 4000 Appliances:
1. Connect the power cable.
2. On the back panel, turn on the Power button to start the appliance.
Note - For the Check Point 4800, when a power supply fails or is not
connected to the outlet, an alarm sounds continuously. If you hear the
alarm, replace the faulty power supply immediately, and connect the
new unit to an A/C outlet ("Removing the Power Supply" on page 25).