Technical data

Replacing Expansion Line Cards
Customer Replaceable Parts Page 31
Check Point 12200 Appliance
The built-in Ethernet ports (ETH1 - ETH7) are not customer replaceable.
Check Point 12400 and 12600 Appliances
Removing Expansion Line Cards
To remove an expansion line card:
1. Power off the appliance and remove the power cords from the power supply units.
2. Loosen the retaining screws on the expansion line card.
3. Holding the screws, pull the expansion line card out of the expansion slot.
4. Place the metal cover over the expansion slot.
5. Tighten the screws on the metal cover.
Installing Expansion Line Cards
To install an expansion line card:
1. Power off the appliance and remove the power cords from the power supply units.
2. Loosen the retaining screws on the metal cover on the front of the appliance.
3. Holding the screws, remove the metal cover.
4. Insert the expansion line card into the expansion slot.
5. Push until the card clicks into place.
6. Tighten the retaining screws on the expansion line card.