Technical data

Replacing Hard Disk Drives on Check Point 12400 and 12600
Customer Replaceable Parts Page 33
Removing a Hard Disk Drive
To remove a hard disk drive from a Check Point 12400 or 12600:
1. Using the key supplied in the toolkit, unlock the drive.
2. Slide the release latch toward the left. The extraction handle pops out.
3. Using the extraction handle, remove the drive from the slot.
Installing a Hard Disk Drive
To install a hard disk drive in a Check Point 12400 or 12600:
1. Slide the replacement hard disk drive into the slot.
2. Push the extraction handle until it closes and the drive clicks into place.
3. Using the key supplied in the toolkit, lock the new drive.